Axle Pkg Cut-Your-Own Ford 9" 31 Spline (2.436" Brake Pilot/Register)

$295.00

Please, select one

Select the previous option first

Select the previous option first

Select the previous option first

Select the previous option first

Select the previous option first

Remember, YOU must cut the final length!

Select the previous option first

Remember, YOU must cut the final length!

Select the previous option first

I verify my axle face to housing end (brake gap/offset) measures 2.5"
In stock
+
Add to wish list

Pair of high-strength, 1541 hardened steel axles with sealed ball wheel bearings are ideal for building custom 9" street rod or street/strip rearends. Streetable, NHRA approved axles can also be used to replace stock 28 spline units (with carrier change). 

These axles come with long splines, which can be cut with a chop saw to the desired length.  

Axle package includes 1/2" x 2" or 3" SCREW-IN lug studs, retainer plates and sealed wheel bearings and INSTALLED. 

Simply measure from your bare housing end to the differential cross and add 2.3".  This is the ideal cut length.  You must measure both sides of your housing!

Once installed, these shafts measure 2.5" from the axle flange to the housing end flange.  Please check your dimensions, as all Ford housing ends and brake dimensions are not the same! YOUR HOUSING ENDS MUST HAVE PROVISIONS FOR INNER AXLE SEALS!

If you need help deriving the correct measurements, use the Housing/Axle Calculator, and make sure the driver and passenger axle lengths fall within the range you select above.  The caclulator will load in a new window, so you can return to this page when you are finished. Remember, YOU must cut the final length!

Customers also bought . . .

 

$195.00
DoctorDiff Gear, 741 (10 spline), 3.23

8 3/4" ring and pinions for 741, 742, or 489 cases. Various ratios.

In stock
 

$70.00
10 Spline 8 3/4"

FORGED STEEL 1350 U-bolt yoke for Dana and Mopar 8 3/4" and 9 1/4" pinions.

In stock
 

$18.00

3/8"-24 x 1 1/4" T-bolts and nuts

In stock