Strange S-60

If "Non-Mopar," specify below
If "Custom/Non-Mopar," specify housing-end to housing-end width at bottom
If "Custom/Non-Mopar," specify center-hole to center-hole dimensions and perch angle below
Not available if no perches are selected above.
"Standard steel" not available if housing is powder coated
"Race" axles are brittle and require a spool. They are not for the street.
Spool is not available if standard 35 Spline axles are selected above
Pro gears are softer and require a spool. They are not for the street.
If "Not Listed," specify requested ratio at bottom (Subject to Availability)
"1350 Large Aftermarket" not for use with 40 spline axles.
Specify any custom measurements here. Please use inches. If you have any questions, please contact us.
In stock

All S60 Rear Assemblies come fully set-up with housing ends, axle bearings, breather vent, filler plug, and drain plug.  Your choice of width, perches, axles, carrier, studs, pinion yoke, cover, and pinion snubber.  Uses Dana 60 components.

If specifying a custom width, enter dimension "C" from the Housing/Axle Calculator.  The caclulator will load in a new window, so you can return to this page when you are finished.

You must choose "request a shipping quote" at checkout.  You will recieve a quote in your email with the exact shipping price.